How can I change the pressure settings on my NETCOM?

How can I change the pressure settings on my NETCOM? Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.2) and navigate to the configuration page. Here you can change the...

read more

What does my NETCOM alarm code mean?

by Joe Hektor | Jul 26, 2017 |

ADH NETCOM, alarm, alarm codes, chart, code, NETCOM, NETCOM FAQs

|
0 Comments

I have an alarm code displayed in my status window, what does it mean?

read more

I occasionally get a high pressure alarm

A high pressure alarm can sometimes occur due to solar gain which is where a portion of the waveguide is exposed to direct sunlight during the heat of the day. The air inside the waveguide expands as it gets hotter causing a rise in pressure.

read more

Why do I keep getting the A12 dew point alarm?

The A12 dew point alarm means that the internal humidity sensor is detecting moisture in the canisters. Usually, an alarm may occur for a few seconds and reset itself before it is seen as the unit determines a need to regenerate a canister.

read more

Why does the Smart Manifold keep shutting off my output port?

The Smart Manifold runs a series of tests at intervals you determine during the setup process in the test “Parameters and Control” page.  One of these is an output kill leak rate. If this rate is set too low or you develop a leak in the system you...

read more

NETCOM red alarm LED is on, how do I find out what is happening and how do I correct it?

Establish communications with the NETCOM dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9). The default page is the status page and here you will see the alarm/s associated with the alarm LED in the...

read more