Leak rates and duty cycles of dehydrators

by David Mays | Nov 29, 2017 |

Dehydrators, Featured, NETCOM FAQs

|
0 Comments

Understanding the leak rates and duty cycles of dehydrators

read more

How can I change the pressure settings on my NETCOM?

How can I change the pressure settings on my NETCOM? Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.2) and navigate to the configuration page. Here you can change the...

read more

How can I communicate with my dehydrator?

The NETCOM dehydrator can communicate via Ethernet, RS422, and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system,...

read more

Can I change the IP address ?

Yes, Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9) and navigate to the configuration page. Here you can change the IP address by either allowing the unit to “obtain...

read more

Can I link two dehydrators together?

By default, a NETCOM is set as a slave so that it will accept commands from any other NETCOM dehydrators that has been configured as a master.

read more

What does my NETCOM alarm code mean?

by Joe Hektor | Jul 26, 2017 |

ADH NETCOM, alarm, alarm codes, chart, code, NETCOM, NETCOM FAQs

|
0 Comments

I have an alarm code displayed in my status window, what does it mean?

read more

My NETCOM keeps turning on and off the compressor, what is going on?

Short cycling of the compressor may be caused by a leak in the pressure system. It could be a leak in the waveguide system, in the dehydrator or in the interconnecting tubing.

read more

Where can I find the latest NETCOM Software updates?

by Joe Hektor | Jul 26, 2017 |

NETCOM, NETCOM FAQs, software, support, website

|
0 Comments

Software updates appear on this website under the Support pulldown under Software. Click here to go to the Software page.

read more

Can I connect more than two dehydrators?

Yes you can connect multiple dehydrators, but this would require the use of an ASM-1 Smart Manifold. In this case, the Manifold is set as the Master to monitor and control the NETCOM’s that are attached to it. This application is used for large...

read more

What is the right dehydrator pressure setting?

The right pressure setting depends on the specification of your waveguide system. You should consult the waveguide manuals or manufacturer for pressure specifications.

read more