How can I change the pressure settings on my NETCOM?

How can I change the pressure settings on my NETCOM? Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.2) and navigate to the configuration page. Here you can change the...

read more

What is the right dehydrator pressure setting?

The right pressure setting depends on the specification of your waveguide system. You should consult the waveguide manuals or manufacturer for pressure specifications.

read more

I occasionally get a high pressure alarm

A high pressure alarm can sometimes occur due to solar gain which is where a portion of the waveguide is exposed to direct sunlight during the heat of the day. The air inside the waveguide expands as it gets hotter causing a rise in pressure.

read more

I have a low pressure alarm what is the problem?

There are numerous possibilities for a low pressure alarm, to narrow the search consider your system as three parts: The waveguide, the dehydrator, and the interconnecting tubing. Isolating the dehydrator from the other two parts will determine if...

read more

How can I communicate with my ASM-1 Smart Manifold?

The ASM-1 Smart Manifold can communicate via Ethernet, RS422 and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system,...

read more

How do I setup my ASM-1 Smart Manifold?

The setup of the ASM-1 smart manifold can be done with the following steps:

read more

Why is there a plug in port number 8?

by David Mays | Jul 26, 2017 |

ASM-1 FAQs, bleed valve, high, NETCOM, pressure, testing

|
0 Comments

Actually, there isn't a plug in port number 8, it is a bleed. If you examine it very closely you will notice that there is a small hole in the middle of it. This is used by the Smart Manifold to bleed off pressure if it senses that it is too high...

read more

Will the Smart Manifold monitor moisture?

by David Mays | Jul 26, 2017 |

ASM-1 FAQs, dehydrator, Manifold, moisture, pressure

|
0 Comments

No. The Smart Manifold monitors the pressure from each dehydrator and directs it to the appropriate port. Each of the dehydrators is responsible for monitoring its own moisture levels and dealing with it accordingly.

read more

ADH NETCOM Pressure Reporting, Lost Communication Fix

read more